<VV> plug problem
Chris C
ricorvair at cox.net
Tue Mar 15 12:07:14 EDT 2011
Couldn't we just wait until the car flips itself over so gravity has
the flakes fall down.
At 11:54 AM 3/15/2011, you wrote:
>depends on which plug , but if easy to get at , try CAREFULLY running a
>thin hacksaw blade in 2 places , not deep enough in shell to hurt threads ,
>then pick it out with a small screwdriver and tiny machinist hammer. then
>vacuum out filings before turning the motor over. i have done this on motors
>a few times , but it was on easy to get at (#2 , #1?) PLUGS. otherwise you
>end up pulling carbs to get a good shot at it (not that bad to do).
>regards, tim colson
> _______________________________________________
>This message was sent by the VirtualVairs mailing list, all
>copyrights are the property
>of the writer, please attribute properly. For help, mailto:vv-help at corvair.org
>This list sponsored by the Corvair Society of America, http://www.corvair.org/
>Post messages to: VirtualVairs at corvair.org
>Change your options: http://www.vv.corvair.org/mailman/options/virtualvairs
> _______________________________________________
More information about the VirtualVairs
mailing list