<VV> Torque, universals

[Daniel Monasterio]

I would use same torque as on connecting rods' nuts (5/16"-24), 20-26 lbs/ft. as sown on page SPECIFICATIONS 4 of 65 shop manual.
Daniel

> Date: Sun, 6 Nov 2011 13:44:42 -0800
> From: kovacsmj at sbcglobal.net
> To: fastvair at yahoogroups.com; virtualvairs at corvair.org
> Subject: <VV> Torque, universals
> 
> Just replacing the rear bearing assy on a '66 and can't find the torque for the 
> straps that holds the universals in . Where, in what book?
> 
>  As an aside, the rebuilt assy from Clark would not fit back into the trailing 
> arm. I had to grind a lot off the yoke to get it back into the arm. Not a clark 
> problem, just the trailing arm was not manufactured to spec, as the one I took 
> out had to be really forced off..
> 
>  MIKE KOVACS
>  _______________________________________________
> This message was sent by the VirtualVairs mailing list, all copyrights are the property
> of the writer, please attribute properly. For help, mailto:vv-help at corvair.org
> This list sponsored by the Corvair Society of America, http://www.corvair.org/
> Post messages to: VirtualVairs at corvair.org
> Change your options: http://www.vv.corvair.org/mailman/options/virtualvairs 
>  _______________________________________________