<VV> [FC] How High Should It Be?

J R Read hmlinc at sbcglobal.net
Mon Oct 31 00:37:25 EDT 2011


Bob,

I'm not sure which jack stands you feel are the "ordinary" ones.

If you have the truck a foot or more above the floor, I would thank that 
would be sufficient.

Later, JR


----- Original Message ----- 
From: "Vairtec Corporation" <Vairtec at optonline.net>
To: <virtualvairs at corvair.org>
Cc: "Corvanatics AB" <corvanatics at corvair.org>
Sent: Saturday, October 29, 2011 7:44 PM
Subject: [FC] How High Should It Be?


> Have to remove the gas tank from my Rampside (1963, 1st-design manual 
> shifter).
>
> Have to do this on my garage floor.  I have done it previously, but
> have had a lift available.  Not this time.
>
> So I have to jack up the truck and put it on jack
> stands.  Question:  How high does the truck need to be to ensure that
> I can get the tank out?  I know that these FC tanks kinda drop down
> and move rearward in the removal process, and I don't want to reach
> the floor before I have cleared the truck.
>
> So -- do ordinary jack stands provide enough clearance?  Or do I need
> to be looking for a taller alternative?
>
> --Bob
>
> _______________________________________________
> Corvanatics mailing list
> Corvanatics at corvair.org
> http://www.vv.corvair.org/mailman/listinfo/corvanatics
> This list sponsored by the Corvair Society of America, 
> http://www.corvair.org/ 



More information about the VirtualVairs mailing list