<VV> Valve adjusting sequence

[Harry Yarnell]

I've always found the shop manual sequence difficult to remember; have to
have a crib sheet.
BUT, if you manually crank the engine to the firing TDC ( pop the
distributor cap, and look where the rotor points) and adjust that cylinder's
two valves, it's foolproof.


-----Original Message-----
From: virtualvairs-bounces at corvair.org
[mailto:virtualvairs-bounces at corvair.org] On Behalf Of Kinzelman, Andy
Sent: Sunday, February 26, 2012 7:52 AM
To: virtualvairs at corvair.org
Subject: <VV> Valve adjusting sequence

Hey,
I promised to help another guy (cold) adjust his valves today; but misplaced
my manuals.  Can anybody remind me the sequence for adjustment?
I believe it's 1(I), 1(E),  3(I), 5(E), then 4(I) and 6(E) - but not
certain. I'm sure I can figure it out; but would prefer to have a printout.
Thanks,
Andy K.
Wisconsin.
 _______________________________________________
This message was sent by the VirtualVairs mailing list, all copyrights are
the property
of the writer, please attribute properly. For help,
mailto:vv-help at corvair.org
This list sponsored by the Corvair Society of America,
http://www.corvair.org/
Post messages to: VirtualVairs at corvair.org
Change your options: http://www.vv.corvair.org/mailman/options/virtualvairs 
 _______________________________________________