<VV> Crank seal surface runout limit

[Doug Mackintosh]

I am in process of tearing down my project car engine, which I plan to rebuild, and I am slowly taking measurements as I get time to tinker. I looked in my Manual for the limit on the crankshaft seal surface runout, but I don't find anything. I measured 0.002 inches. Does anyone know what is acceptable? 


Thanks for any insight!

-- Doug Mackintosh
Corsa member since 1996
Corsa/NC member since 1996, Virtual Vairs member
Corvair owner 1969-1971 and 1996-on