<VV> Crank seal surface runout limit

[Mark Durham]

Doug, I do not remember any criteria for this. There are measurements
at the bearings. I'd say that is about as true as one can get. As long
as nothing else prevents it, polish and reinstall. Mark Durham

Sent from my Windows Phone
From: Doug Mackintosh
Sent: 1/13/2012 17:07
To: Virtual Vairs
Subject: <VV> Crank seal surface runout limit
I am in process of tearing down my project car engine, which I plan to
rebuild, and I am slowly taking measurements as I get time to tinker.
I looked in my Manual for the limit on the crankshaft seal surface
runout, but I don't find anything. I measured 0.002 inches. Does
anyone know what is acceptable?


Thanks for any insight!

-- Doug Mackintosh
Corsa member since 1996
Corsa/NC member since 1996, Virtual Vairs member
Corvair owner 1969-1971 and 1996-on
 _______________________________________________
This message was sent by the VirtualVairs mailing list, all copyrights
are the property
of the writer, please attribute properly. For help, mailto:vv-help at corvair.org
This list sponsored by the Corvair Society of America, http://www.corvair.org/
Post messages to: VirtualVairs at corvair.org
Change your options: http://www.vv.corvair.org/mailman/options/virtualvairs
 _______________________________________________