<VV> Powerglide Rebuild
PETER INMAN
monza1965 at yahoo.com
Tue Mar 6 11:26:02 EST 2012
I understand that the low servo piston seal is included in Clarks part #C3591 along with the (2) clutch drum seals but I cant find or understand where the pinion shaft seal is located that is in that 4 piece kit. Can someone please inlighten me on this before I get started with my PG rebuild so that I fully understand things before I get started? Looking for help here. Thanks
Pete Inman
65 Monza
61 Rampside
________________________________
From: Tom Hughes <corvairdad at gmail.com>
To: James Davis <jld at wk.net>
Cc: VirtualVairs AA <virtualvairs at corvair.org>
Sent: Sunday, March 4, 2012 7:14 PM
Subject: Re: <VV> Powerglide Rebuild - Should This Be Happening
James, that worked perfectly. Thanks so much for the wise instruction given
quickly.
On Sun, Mar 4, 2012 at 6:22 PM, James Davis <jld at wk.net> wrote:
> The wear plate is not centered or reversed. Loosen the five bolts until
> the pump turns freely. rotate the pump one full turn, then turn it back
> the other direction slightly. Tighten to opposite bolts slightly 9your
> choice of which two. Repeat the process outil these bolts are torqued to
> specks, then start thew process with the other three. Sometimes it takes a
> couple times until everything seats well.
_______________________________________________
This message was sent by the VirtualVairs mailing list, all copyrights are the property
of the writer, please attribute properly. For help, mailto:vv-help at corvair.org
This list sponsored by the Corvair Society of America, http://www.corvair.org/
Post messages to: VirtualVairs at corvair.org
Change your options: http://www.vv.corvair.org/mailman/options/virtualvairs
_______________________________________________
More information about the VirtualVairs
mailing list