<VV> Heim joint--can't install

[Michael Kovacs]

Try lowering the back of the engine. It may change the geometry just enough to 
align the bolt.
 MIKE KOVACS




________________________________
From: Ernie Sanders <epssax at yahoo.com>
To: "VirtualVairs at corvair.org" <VirtualVairs at corvair.org>
Sent: Thu, October 11, 2012 4:39:30 PM
Subject: <VV> Heim joint--can't install

Have a 67 coupe.  Replaced a driver side half shaft.  Had to remove the heim 
joint to get it in.  Now I can't get the joint back in either end.  Been working 
3 days on it!
 
The wheel hub appears to be twisted in such a way that the bolt that goes thru 
the heim joint won't go through.  I have tried the same thing on the 
differential end, too.