<VV> electrical help

[shortle]

The tachometer is wired to the negative side of the ignition coil. The side that goes to the distributor.
Timothy Shortle in Durango Colorado 81301


-----Original Message-----
>From: judynrandy at comcast.net
>Sent: Sep 12, 2013 2:51 PM
>To: virtualvairs at corvair.org
>Subject: <VV> electrical help
>
>I have a problem.  I'm in the process of installing a Spyder dash into my '60.  I'm doing so for the acquisition of the tach.  After scouring the shop manuals for a couple of hours, I can't seem to find a clear, concise, and understandable wiring diagram of said tach.  The '64 shop manual showed there is one, but the wire goes off into oblivion.  Same for the '65.  None of them show the tach in the dash or any associated wiring. 
>   So, could anyone explain how to properly wire in a tach?  Or better yet, furnish a wiring diagram for said installation? 
>No reasonable reply refused.  Thanks a million for your help. 
>  
>Randy (Cap'n) Hook 
>'60 700 4dr 110/4spd 
>'63 ragtop 110/4spd 
>'65 monza 4dr 84/pg 
> _______________________________________________
>This message was sent by the VirtualVairs mailing list, all copyrights are the property
>of the writer, please attribute properly. For help, mailto:vv-help at corvair.org
>This list sponsored by the Corvair Society of America, http://www.corvair.org/
>Post messages to: VirtualVairs at corvair.org
>Change your options: http://www.vv.corvair.org/mailman/options/virtualvairs 
> _______________________________________________