<VV> Stuck Corvair
Michael Kovacs
kovacsmj at yahoo.com
Sun Sep 22 13:35:49 EDT 2013
I think I'd try to grind the flat heads off first. I'd use a Dremel type tool with a small grinding wheel.
________________________________
From: "Shelrockbored at aol.com" <Shelrockbored at aol.com>
To: virtualvairs at corvair.org
Sent: Saturday, September 21, 2013 11:05 PM
Subject: Re: <VV> Stuck Corvair
What does one cut the pins off with? They are flush with the backing
plate. Do you drill them out?
SVS
In a message dated 9/21/2013 9:24:51 P.M. Eastern Standard Time,
xramzl1 at yahoo.com writes:
A good trick for getting frozen drums off is to go to the rear of the
backingplate and cut the heads off of the brake shoe retaining pins. Then get a
pry bar into the bottom between the backing plate and drum and pry the
drum off upward.
No hammer needed.
RCS.
More information about the VirtualVairs
mailing list