<VV> '65 Corvair heater FAN motor shaft keyed?

[Harry Yarnell (Verizon)]

I doubt that will work with pot metal.




-----Original Message-----
From: VirtualVairs [mailto:virtualvairs-bounces at corvair.org] On Behalf Of
Jay Maechtlen via VirtualVairs
Sent: Tuesday, December 09, 2014 7:53 PM
To: corvairduval at cox.net; virtualvairs at corvair.org
Subject: Re: <VV> '65 Corvair heater FAN motor shaft keyed?

On 12/9/2014 2:47 PM, corvairduval--- via VirtualVairs wrote:
> Fan hub is "pot metal". If you have a way of brazing that, let me know.
>
> I've never tried, but maybe tin/lead solder with lots of flux might work?
>
> Frank DuVal

Sounds like it would be worth a try!


--
Jay Maechtlen SoCal '61 2-dr modified w/fiberglass skin, transverse 3.8
Buick V6 TH440T4 trans  _______________________________________________
This message was sent by the VirtualVairs mailing list, all copyrights are
the property of the writer, please attribute properly. For help,
mailto:vv-help at corvair.org This list sponsored by the Corvair Society of
America, http://www.corvair.org/ Post messages to: VirtualVairs at corvair.org
Change your options: http://www.vv.corvair.org/mailman/options/virtualvairs
 _______________________________________________