<VV> Is there a trick late to LM Monza rear grille install / remove?

[J. R. Read]

A long extension on a 1/4 inch drive.  Sheet metal screws about 6 - 8 inches 
above the holes in the top of the air grill.  Don't recall what size socket 
just now.

Later, JR

----- Original Message ----- 
From: "Charlie via VirtualVairs" <virtualvairs at corvair.org>
To: <virtualvairs at corvair.org>
Sent: Sunday, July 06, 2014 1:03 PM
Subject: <VV> Is there a trick late to LM Monza rear grille install / 
remove?


> Hi again ~
>
> Now that the 140 engine is in the 1967 Monza, I did a little cosmetic 
> work, such as trying to install the rear grille...
>
> The Monza does not have a removable panel in it (like the Corsa panel 
> does) to get at the screws.
>
> So, is there a trick to this, or is it just a matter of poking around 
> until I get lucky?
>
> I get lucky with one of them, but I was not as lucky for the next hour 
> before I gave up ~ is that why so many LMs only have a few screws holding 
> the rear grille?
>
> If there is there a trick to this, what is it?
>
> Thanks!
> Charlie
>
> _______________________________________________
> This message was sent by the VirtualVairs mailing list, all copyrights are 
> the property
> of the writer, please attribute properly. For help, 
> mailto:vv-help at corvair.org
> This list sponsored by the Corvair Society of America, 
> http://www.corvair.org/
> Post messages to: VirtualVairs at corvair.org
> Change your options: 
> http://www.vv.corvair.org/mailman/options/virtualvairs
> _______________________________________________ 


---
This email is free from viruses and malware because avast! Antivirus protection is active.
http://www.avast.com