<VV> Need electrical help on tailights
gergwerks at comcast.net
Sat Oct 4 22:19:41 EDT 2014
Would the running lift still work with a bad ground?
I would use a DVOM and test the contact inside the light socket when someone hits the brakes. Make sure juice is getting there.
> On Oct 4, 2014, at 9:13 PM, MarK Durham via VirtualVairs <virtualvairs at corvair.org> wrote:
> If you have power and the bulb is good you probably have a bad ground. My
> problem was between the socket and housing. I had to add a screw at that
> joint to make the connection.
> Mark Durham 62 Coupe
> Mark Durham.
> On Oct 4, 2014 6:01 PM, "John Gull via VirtualVairs" <
> virtualvairs at corvair.org> wrote:
>> I am not electriclly inclined, so would appreciate any advice. I have a LM
>> that the right taillight does not light up with the brakes on, but the
>> light does work. I have tested the bulb to eliminate this. Also the is a
>> wiring harness about 3 years ago. Tried to figure out the wiring diagram
>> not knowing how to figure out. Any suggestions? Thanks John Gull
>> This message was sent by the VirtualVairs mailing list, all copyrights are
>> the property
>> of the writer, please attribute properly. For help, mailto:
>> vv-help at corvair.org
>> This list sponsored by the Corvair Society of America,
>> Post messages to: VirtualVairs at corvair.org
>> Change your options:
> This message was sent by the VirtualVairs mailing list, all copyrights are the property
> of the writer, please attribute properly. For help, mailto:vv-help at corvair.org
> This list sponsored by the Corvair Society of America, http://www.corvair.org/
> Post messages to: VirtualVairs at corvair.org
> Change your options: http://www.vv.corvair.org/mailman/options/virtualvairs
More information about the VirtualVairs