<VV> Re-hang a door alone?

[MarK Durham]

I have been reading thus thread with interest. I have 4 nos hinges to
install. I think I will do one at a time so I have fewer problems. :):)
Mark Durham
62 900 Coupe
4 speed Red/Red
On Feb 28, 2015 4:04 PM, "Ignacio Valdes via VirtualVairs" <
virtualvairs at corvair.org> wrote:

> Thumbs down on the E-Z store Door Alignment Bar. Did not help at all, would
> not fit. I got my son to lift it up and it works now. -- IV
>
> On Sun, Feb 22, 2015 at 10:30 PM, Ignacio Valdes <ivaldes at hal-pc.org>
> wrote:
>
> > Hi, My 1964 coupe passenger door opens and closes with difficulty
> probably
> > because I re-hung it by myself and didn't do a very good job. Is there a
> > way to re-hang it alone so that it works better? I had to hold it and
> > tighten at the same time obviously not very well.
> >
> > Are these any good?
> >
> > Steck Manufacturing 21845 E-Z Store Door Alignment Bar
> >
> >
> >
> http://www.amazon.com/Steck-Manufacturing-21845-Store-Alignment/dp/B000JFL8S4/ref=sr_1_1?s=automotive&ie=UTF8&qid=1424662804&sr=1-1&keywords=door+alignment+tool
> >
> > -- IV
> >
>  _______________________________________________
> This message was sent by the VirtualVairs mailing list, all copyrights are
> the property
> of the writer, please attribute properly. For help, mailto:
> vv-help at corvair.org
> This list sponsored by the Corvair Society of America,
> http://www.corvair.org/
> Post messages to: VirtualVairs at corvair.org
> Change your options:
> http://www.vv.corvair.org/mailman/options/virtualvairs
>  _______________________________________________
>