<VV> 63 Turbo Efi Boost Test

kevin nash wrokit at hotmail.com
Thu Mar 12 20:54:47 EDT 2015


Frank- You are preaching to the choir!!!☺ Actually, it is on my list of things to do. I have a Aquamist 1s that I've been
procrastinating about putting back on. It has been so long since I last used it, I think it would be wise to take it apart and
inspect it before using.  In the meantime, I've found a newer pump that has the same output as my current pump, but 
pushes water at 1000 psi v.s. 100psi for the 1s, it also is very quiet, smaller and uses less current to operate.... I'm getting
tempted to just bite the bullet and get the new pump! A couple other projects are going to be to put twin 48mm throttle
bodies on in place of the twin 45's on the weber, and step bore the intake on the compressor housing so as to further
reduce the vacuum at higher boost levels, and of course, get that waste gate installed!!
Kevin Nash
63 Turbo, daily driver, EFI
 
Date: Thu, 12 Mar 2015 12:20:55 -0400
From: frankcb at aol.com
To: wrokit at hotmail.com; virtualvairs at corvair.org
Subject: Re: <VV> 63 Turbo Efi Boost Test


Kevin, you may need to add water injection (to keep out of detonation) at least until you get your waste gate setup installed.  It worked for Tom Keosababian when he ran over 150 mph (on gasoline) and later over 170 mph (on propane) at Bonneville.

    Frank Burkhard

    Boonton, NJ 




 

 		 	   		  


More information about the VirtualVairs mailing list