<VV> PG engine break up at 4400 rpm

[Charles Cromwell]

How about valve float. Chuck 

    On Friday, April 15, 2016 5:47 PM, Michael Kovacs via VirtualVairs <virtualvairs at corvair.org> wrote:
 

  I will be running my PG 140 at the New York Safety Track again this year. Last year when accelerating down the straight in low, the engine pulled well until about 4400 rpm where the engine seemed to just stop accelerating. 
(heads milled to .035 squish, balanced forged pistons and con rods. OTTO 20 cam, etc.)

  I am running igniter ll and the recommended  flame thrower coil. I just changed the spark plug wires to 8mm and new AC 44F. Timing set at 16. running 87 octane.  Same  4400 results in test run yesterday.
 My Fitch with similar internals, I can shift at 5500 with ease with it still pulling.
Any ideas??
 _______________________________________________
This message was sent by the VirtualVairs mailing list, all copyrights are the property
of the writer, please attribute properly. For help, mailto:vv-help at corvair.org
This list sponsored by the Corvair Society of America, http://www.corvair.org/
Post messages to: VirtualVairs at corvair.org
Change your options: http://www.vv.corvair.org/mailman/options/virtualvairs
Archives: http://www.vv.corvair.org/archive.htm
 _______________________________________________