<VV> '64 and '65-69 engine fans

[Sethracer at aol.com]

Earlier bolts are a larger diameter  - Per GM Parts book Nov  1976
 
Early one is 5/16-18 x 3/4"
Later one is 1/4-20 x 3/4"
 
Pretty sure the four holes size would match. Perhaps the  large center hole 
is a different size? I'm too lazy to go out into the  garage and check my 
stack of fans and bearings. How about you, Harry?  <grin>
 
-Seth
 
 
 
 
In a message dated 1/31/2016 11:25:52 A.M. Pacific Standard Time,  
virtualvairs at corvair.org writes:

What's  the difference between the '64 fan and later fans?

The only difference  I can see is the four mounting holes, but which one has
the bigger  holes?

Any other  differences?









---------------------------

Harry  Yarnell

Perryman Garage  &

Orphanage

harryyarnell at verizon.net



_______________________________________________
This  message was sent by the VirtualVairs mailing list, all copyrights are 
the  property
of the writer, please attribute properly. For help,  
mailto:vv-help at corvair.org
This list sponsored by the Corvair Society of  America, 
http://www.corvair.org/
Post messages to:  VirtualVairs at corvair.org
Change your options:  http://www.vv.corvair.org/mailman/options/virtualvairs
Archives:  http://www.vv.corvair.org/archive.htm
_______________________________________________