<VV> PG installation problem

Frank DuVal corvairduval at cox.net
Tue Jun 7 20:27:36 EDT 2016

Flex plate on in correct direction?


I'm with Harry, seat the torque converter fully on the snout of the 
transaxle. Turn while pushing it on.

Frank DuVal

On 6/7/2016 4:43 PM, Michael Kovacs via VirtualVairs wrote:
>   I Replaced the torque converter due to a poor starter ring. 1966 4 dr. Now I cannot get the bell housing to completely mate up to the transaxle flange.
>   It stops exactly 5/8 of an inch from mating and when pulled back very little and pushed forward the engine stops with a solid thud. Like something is not alighted inside the transaxle.
>   What the heck am I doing wrong?  Same transaxle and same bell housing.
> I need help regardless even if you are just guessing.

More information about the VirtualVairs mailing list