<VV> PG installation problem

[Harry Yarnell (Verizon)]

Sounds like you haven't seated the TQ on the final spline.



-----Original Message-----
From: VirtualVairs [mailto:virtualvairs-bounces at corvair.org] On Behalf Of Michael Kovacs via VirtualVairs
Sent: Tuesday, June 07, 2016 4:43 PM
To: TIM COLSON; VV
Subject: <VV> PG installation problem

 I Replaced the torque converter due to a poor starter ring. 1966 4 dr. Now I cannot get the bell housing to completely mate up to the transaxle flange.
 It stops exactly 5/8 of an inch from mating and when pulled back very little and pushed forward the engine stops with a solid thud. Like something is not alighted inside the transaxle.
 What the heck am I doing wrong?  Same transaxle and same bell housing. 
I need help regardless even if you are just guessing.
 _______________________________________________
This message was sent by the VirtualVairs mailing list, all copyrights are the property of the writer, please attribute properly. For help, mailto:vv-help at corvair.org This list sponsored by the Corvair Society of America, http://www.corvair.org/ Post messages to: VirtualVairs at corvair.org Change your options: http://www.vv.corvair.org/mailman/options/virtualvairs
Archives: http://www.vv.corvair.org/archive.htm
 _______________________________________________