<VV> PG parts

[Seth Emerson]

At one time, Larry Claypool offered a service that included machining the PG inside and adding another clutch plate to raise the effective capacity. I am sure Larry no longer does this, but does anybody know someone who can do this? 



-----Original Message-----
From: James Koenig via VirtualVairs <virtualvairs at corvair.org>
To: virtualvairs <virtualvairs at corvair.org>
Sent: Thu, Aug 16, 2018 8:13 am
Subject: <VV> PG parts

Got the new torque converter on the way. Still need high performance
clutches for PG. Where do I get these?
Jim
 _______________________________________________
This message was sent by the VirtualVairs mailing list, all copyrights are the property
of the writer, please attribute properly. For help, mailto:vv-help at corvair.org
This list sponsored by the Corvair Society of America, http://www.corvair.org/
Post messages to: VirtualVairs at corvair.org
Change your options: http://www.vv.corvair.org/mailman/options/virtualvairs
Archives: http://www.vv.corvair.org/archive.htm
 _______________________________________________