<VV> 64 circuit problem

Hugo Miller hugo at aruncoaches.co.uk
Sat Jun 16 18:43:17 EDT 2018


There might be current leaking back through the starter solenoid. Not 
sure how this could happen, but anything's possible - the starter 
solenoid is connected to the pos terminal of the coil, so whatever you 
put into the coil might be leaking back down that line & going 
somewhere, & eventually to ground.
Best disconnect EVERYTHING & run it jumper cables direct from the 
battery.


On 2018-06-16 11:44, kevin nash via VirtualVairs wrote:
> It might be worth verifying that when the points are open, no current
> is going to ground... it sure seems like
> everything else has been replaced, except for the distributor. It may
> be that the short is somehow, somewhere
> in the distributor.
> Kevin Nash
>  _______________________________________________
> This message was sent by the VirtualVairs mailing list, all
> copyrights are the property
> of the writer, please attribute properly. For help,
> mailto:vv-help at corvair.org
> This list sponsored by the Corvair Society of America,
> http://www.corvair.org/
> Post messages to: VirtualVairs at corvair.org
> Change your options: 
> http://www.vv.corvair.org/mailman/options/virtualvairs
> Archives: http://www.vv.corvair.org/archive.htm
>  _______________________________________________



More information about the VirtualVairs mailing list