<VV> Plug in carb riser

[Spencer Shepard]

I made tool for this by bending an old pushrod in a vice about an inch from one end.
________________________________
From: VirtualVairs <virtualvairs-bounces at corvair.org> on behalf of Hubert Smith via VirtualVairs <virtualvairs at corvair.org>
Sent: Saturday, May 4, 2019 7:36 PM
To: virtualvairs at corvair.org
Subject: <VV> Plug in carb riser

You wouldn't think so considering the angles involved but a long common drift punch
 Will knock it out, no damage every time.  Remove the tube first and go in through that hole, across the intake opening and against the plug.  If that doesn't work I will eat my hat., no ketchup.

Sent from my iPad
 _______________________________________________
This message was sent by the VirtualVairs mailing list, all copyrights are the property
of the writer, please attribute properly. For help, mailto:vv-help at corvair.org
This list sponsored by the Corvair Society of America, http://www.corvair.org/
Post messages to: VirtualVairs at corvair.org
Change your options: http://www.vv.corvair.org/mailman/options/virtualvairs
Archives: http://www.vv.corvair.org/archive.htm
 _______________________________________________