<VV> anybody seen this V8 conversion? (Dave)

[jvhroberts at aol.com]

The side bearings are larger than what's in a Corvair transaxle. And being a spiral bevel final drive, the gear loads are lower than in a hypoid drive. 


-----Original Message-----
From: Dave Leonard via VirtualVairs <virtualvairs at corvair.org>
To: virtualvairs at corvair.org
Sent: Thu, Dec 17, 2020 12:50 pm
Subject: Re: <VV> anybody seen this V8 conversion? (Dave)

Amazing workmanship!  

I'm puzzled by the transaxle however.  Not sure what it's from - Porsche?
But I didn't think any like this could take the axle side-loads as the upper
link for the suspension?

http://www.lonniesplace.com/corvair-project

Dave

 _______________________________________________
This message was sent by the VirtualVairs mailing list, all copyrights are the property
of the writer, please attribute properly. For help, mailto:vv-help at corvair.org
This list sponsored by the Corvair Society of America, http://www.corvair.org/
Post messages to: VirtualVairs at corvair.org
Change your options: http://www.vv.corvair.org/mailman/options/virtualvairs
Archives: http://www.vv.corvair.org/archive.htm
 _______________________________________________