[FC] Head ligts and running lights

[J R Read_HML]

Sounds right.  If the dimmer switch is giving you a good "click" then you 
just need to unscrew it (I think it is two bolts - might be three) and clean 
the floor and holes and screws so you'll have a good ground when you 
reinstall it.  Should work normal then.  If not, replace dimmer switch.  Oh, 
also clean the plug for the dimmer switch.

BTW - in the '60s, they were called - parking lights.

Attachments (if any) are scanned with anti-virus software.

Later, JR
'61 Rampside Standard 4/110
'65 Monza Convertible 4/140
'66 beater Coupe - icemobile 4/140

----- Original Message ----- 
From: "TiM M" <mr_tim34@yahoo.com>
To: "FC list" <corvanatics@corvair.org>
Sent: Wednesday, November 10, 2004 1:08 AM
Subject: [FC] Head ligts and running lights


>     A question about how the lights on the Rampside
> work. When I pull the headlight switch to the first
> position the four running lights lite. When I pull it
> to the second position the outside two headlights
> light and the front running lights go out. Is this the
> correct operation? My hi-low switch on the floor
> doesn't do anything but make the two outside light
> flicker. I was curious as to what happens when the
> high beams are switched on, do the outer lights go off
> and the inner ones go on, or do all four light at
> once? I'm also assuming the outer head lights are the
> low beams?
>
> Thanks,
>
> TiM
>
>
>
> __________________________________
> Do you Yahoo!?
> Check out the new Yahoo! Front Page.
> www.yahoo.com
> _______________________________________________
> Corvanatics mailing list
> Corvanatics@corvair.org
> http://www.vv.corvair.org/mailman/listinfo/corvanatics
> This list sponsored by the Corvair Society of America, 
> http://www.corvair.org/