[FC] Emblem Install

[VairMech at aol.com]

In a message dated 12/2/2005 12:36:34 PM Eastern Standard Time,  
jforgey4 at yahoo.com writes:

Any  thoughts on that
emblem ?



>>>>>>>>>>>
    Sure, 
    If you want to install that emblem you will need to  find the push clips 
that go over the studs. Most any auto parts should have  them. When you get 
them find out what size hole they fit into so you know what  size to finish 
drill.
    Put a piece of tape where you want to mount the  emblem. Draw a level and 
straight line on the tape. Now place the emblem so the  mounting prongs are 
on the line and placed where you want it. Mark very  carefully where the prongs 
are. Now drill small holes where the prong marks  intersect the line on the 
tape, being carefull not to wander with the drill bit.  Next, with a drill bit 
of the size needed for the clips, which will be gigger  than the prongs, drill 
the needed holes. Remove the tape, insert the clips into  the holes and then 
push on the emblem and it is installed.
 
    Upside down???? OOOPS.
 
    Ken Hand