[FC] rear turn signal woes

[tkalp at cox.net]

Check and see if you are getting power to the socket with the turn 
signal on.  If not you may need to clean, adjust, and or replace your 
turn signal switch on the steering post.

Terry Kalp

On Wed, Jan 13, 2010 at 9:17 PM, Ben and Lynn Stiles wrote:

> Hi all-
>
> I can't seem to get my rear passenger side turn signal working. The 
> socket springs are a bit tight. I lubed them and worked them until 
> they were a bit better. I cleaned the body to tail light-housing 
> ground connection. I get tail lights and brake...but the turn signal 
> will not work.
>
> All other turn signals work fine. Any ideas? Has anyone successfully 
> installed an aftermarkey socket? I tried this once but it did not work 
> as well as hoped.
>
> Could it be the bulb (not likely since the brake light works/same 
> filament??)
>
> Any advice appreciated. Thanks!  Ben
> _______________________________________________
> Corvanatics mailing list
> Corvanatics at corvair.org
> http://www.vv.corvair.org/mailman/listinfo/corvanatics
> This list sponsored by the Corvair Society of America, 
> http://www.corvair.org/