[FC] Engine Cover Bolts and Engine mount

[Bryan Blackwell]

I have not seen this - however, you might check the front mounts as  
well, make sure the trans isn't cocked a little.  In any case, there  
is also a metal sleeve that goes between the top and bottom retainers,  
you should make sure you have all the pieces, or pick up a complete  
used one to use with new bushings.

--Bryan

On Jan 20, 2010, at 6:56 PM, kenharri at comcast.net wrote:

> On a different matter, my re ar motor mount is displaced to the  
> right to the point where the top retainer disk nearly contacts the  
> inside of the housing (about 1/2 inch off center?).  I am guessing  
> that the bottom retainer has slipped or is not present.  Anyone have  
> any experience with this?