[FC] muffler hanger replacement on Lakewood

[J R Read]

Assuming that a Lakewood is like a car hanger (I don't know), there are two 
bolts holding the metal (more or less triangular piece) to the head - one at 
the top corner and one at the bottom corner.  If I recall correctly, the 
triangular piece slides behind another piece of shrouding and you  might 
have to slot the upper hole in order to avoid removing additional pieces.
Later, JR
CCE CORSA CORVANANTICS SCG member
'61 Rampside Standard 4/110
'65 Monza Convertible 4/140
"Keep the Love Alive"

----- Original Message ----- 
From: "Jim Forgey" <jforgey4 at yahoo.com>
To: "corvanatics" <corvanatics at corvair.org>
Sent: Wednesday, June 29, 2011 8:34 PM
Subject: [FC] muffler hanger replacement on Lakewood


>
>
>
>
> Hi all,
>
> non- FC question.
>
> I am replacing the muffler hanger on my 61 Lakewood with the Clarks All in 
> one
> part (complete metal and rubber hanger)
>
> Went to take off what  is left of the old hanger (just the part bolted to 
> the
> engine with a bit of the leather strap). Removed the bolt at the bottm 
> right
> (just below valve cover) and thought the piece would slide out  with some
> coaxing- before I start tapping (or swinging) with a hammer - is there a 
> bolt
> somewhere that I can't see? I looked and felt around with no result.
>
> Any help as always is welcome.
>
> Jim Forgey
> _______________________________________________
> Corvanatics mailing list
> Corvanatics at corvair.org
> http://www.vv.corvair.org/mailman/listinfo/corvanatics
> This list sponsored by the Corvair Society of America, 
> http://www.corvair.org/
>
> _______________________________________________
> Corvanatics mailing list
> Corvanatics at corvair.org
> http://www.vv.corvair.org/mailman/listinfo/corvanatics
> This list sponsored by the Corvair Society of America, 
> http://www.corvair.org/