[NoVa-Corvairs] Jan 31

[Ron]

Hi Richard! When we did Darrin's clutch job a few years ago, we had to replace the studs in the exhaust logs which required drilling and tapping in new studs.  You might also want to pick up a set of graphite exhaust packings while you're at the ranch.  I will plan to bring my tap an die set just in case.

Ron

Sent from my iPad

> On Jan 25, 2015, at 6:21 AM, RICHARD via Novacc-list <novacc-list at corvair.org> wrote:
> 
> 
> Bob
> 
> I told Jeff to get me everything that I need(clutch disk pressure plate flywheel pilot
> bushing  throwout bushing seals split ring gaskets)
> Does anybody have a seal puller(if we need one) if nobody has one I will buy
> one from Jeff.
> I have a heavy duty floor jack and some jack stands I will buy the cleaner
> Thanks for the help
> 
> Richard
> From: "Bob Marshall via Novacc-list" <novacc-list at corvair.org>
> To: bryan at skiblack.com, novacc-list at corvair.org
> Sent: Saturday, January 24, 2015 8:23:06 PM
> Subject: Re: [NoVa-Corvairs] Jan 31
> 
> I have 2 tall jack stands, engine cart (if needed) and seal puller.  I will also bring my low profile floor jack (can't have too many floor jacks) battery impact wrench. I also have gasgachinch, permatex sealant and Anti Seize. 
> 
> Someone should bring their tool box in the event we need something that Richard may not have.  
> 
> Other things that come to mind.
> Moly grease
> Shop towels
> PB Blaster
> Cans of brake kleen
> New Gear Oil.  Might consider changing it unless it is fairly new.  
> Oil and oil filter.
> Extra input shaft split ring.
> Cotter pins
> 
> 
> It might be a good idea for someone go over to Richards before the weekend to look under the car for signs of any issues that could be taken care of while the power pack is out.   U joints, side axle seals heater hose condition, shifter coupling etc.  
> I recall Richard said that the Corvair Ranch did a lot of work on the car so we can probably assume the flywheel is bolted and the PP is ok. 
> 
> Richard.  Send of a list of what you have ordered from the Corvair Ranch just so we know what will be there on Saturday.  
> 
> I live in Reston and could go during the week but as always two sets of eyes are better than one.  
> 
> Bob 
>  
>  
> 
> On 01/24/15, Bryan Blackwell via Novacc-list<novacc-list at corvair.org> wrote:
>  
> I don't believe Richard has done a Corvair clutch or pulled the engine previously. We should bring any special tools required. Let's see:
> 
> Tall jack stands (Doug may have)
> ATV lift or comparable (I have)
> Torque wrenches (I have)
> Bellhousing alignment dowels (I have)
> 
> Need:
> 
> Floor jack is preferable - Richard?
> Seal puller for the input shaft seal
> Yoke puller
> Flywheel bolt sealant
> 
> What else?
> 
> --Bryan
> 
> > On Jan 24, 2015, at 3:01 PM, Bob Marshall via Novacc-list <novacc-list at corvair.org> wrote:
> > 
> > Hi Richard. 
> > 
> > Is there anything in the way of specialty tools we need to bring next Saturday to get your clutch job done? Torque wrench, axle yoke puller or seal puller? Just trying to anticipate anything we may need.
> > 
> > It will be a fun day.
> > 
> > Bob 
> > 
> > 
> > On 01/24/15, RICHARD via Novacc-list<novacc-list at corvair.org> wrote:
> > 
> > Hello everybody
> > 
> > I just ordered all the parts I need.I am going to drive up to the
> > Corvair Ranch next Wed or Thur to pick up the parts
> > If anybody needs something from Corvair Ranch let Jeff
> > know and I will be glad to pick it up
> > 
> > Looking forward to Next Sat
> > 
> > Richard
> > 
> > 703 987 5879
> > 
> > 
> > _______________________________________________
> > Novacc-list mailing list
> > Novacc-list at corvair.org
> > http://www.vv.corvair.org/mailman/listinfo/novacc-list
> > _______________________________________________
> > Novacc-list mailing list
> > Novacc-list at corvair.org
> > http://www.vv.corvair.org/mailman/listinfo/novacc-list
> 
> _______________________________________________
> Novacc-list mailing list
> Novacc-list at corvair.org
> http://www.vv.corvair.org/mailman/listinfo/novacc-list
> 
> _______________________________________________
> Novacc-list mailing list
> Novacc-list at corvair.org
> http://www.vv.corvair.org/mailman/listinfo/novacc-list
> 
> _______________________________________________
> Novacc-list mailing list
> Novacc-list at corvair.org
> http://www.vv.corvair.org/mailman/listinfo/novacc-list
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://www.vv.corvair.org/pipermail/novacc-list/attachments/20150125/8fb4c1ea/attachment-0001.html>