[NoVa-Corvairs] Jan 31

[Frank DuVal]

Yep, always have the stainless steel stud kits on hand. You will need to 
remove the crossover pipe to separate the drivetrain. Good catch.

Also, someone mentioned needing gear lube. Not always needed, but a must 
to have ready to add in case some leaks. OK, it always leaks out!:-D

You will need GL4 for this application (4 speed manual transmission). 
GL4 can be bought by the gallon at Car Quest.  Read Richard in Bolivia's 
paper on tranny oil:

http://www.widman.biz/uploads/Transaxle_oil.pdf

Frank DuVal


On 1/25/2015 9:56 AM, Ron via Novacc-list wrote:
> Hi Richard! When we did Darrin's clutch job a few years ago, we had to 
> replace the studs in the exhaust logs which required drilling and 
> tapping in new studs.  You might also want to pick up a set of 
> graphite exhaust packings while you're at the ranch.  I will plan to 
> bring my tap an die set just in case.
>
> Ron

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://www.vv.corvair.org/pipermail/novacc-list/attachments/20150125/5d96fd5d/attachment.html>