<VV> Frustrating problem

[Roger Gault]

Terry,
Little rubber tubes between the crossover pipe and the carb bases?  Get
hot - start to leak?

Roger Gault

----- Original Message ----- 
From: "Terry Kalp" <tkalp@cox.net>
To: <virtualvairs@corvair.org>
Sent: Sunday, August 15, 2004 1:48 PM
Subject: <VV> Frustrating problem


> Group,
>
> I need your help and advice trying to solve a fellow Corvair owner's
problem.
> He has a '66 Corvair Monza 140 hp PG convertible.  It starts and runs fine
for
> about 15 minutes then it won't run well under 25 mph, it will idle fine,
but
> not in gear . . . put it in gear and it dies.
>
> What has been done so far:
>
> A new coil has been installed.
>
> It has a Pertonics I . . . we tried changing back to points, but it didn't
> help
>
> Adjusted and checked the sync on the carbs, check out fine.
>
> Secondary carbs are not leaking air or gas.
>
> Timing set and distributor is the correct 339 for the car.
>
> Vacuum Advance is working.
>
> Chokes are working.
>
> Gas cap is vented.
>
> Suggestions?
>
> Terry Kalp
> _______________________________________________
> This message was sent by the VirtualVairs mailing list, all copyrights are
the property
> of the writer, please attribute properly. For help,
mailto:vv-help@corvair.org
> This list sponsored by the Corvair Society of America,
http://www.corvair.org/
> Post messages to: VirtualVairs@corvair.org
> List info: http://www.vv.corvair.org/mailman/listinfo/virtualvairs
> _______________________________________________