<VV> Exhaust manifold question
Sethracer at aol.com
Sethracer at aol.com
Wed Jun 8 23:28:51 EDT 2005
In a message dated 6/8/2005 3:59:04 PM Pacific Standard Time,
hyarnell1 at earthlink.net writes:
Oye; the worst case. my ONLY success with exhaust studs is to get the log
ears as red as possible with a torch, and attempt to wiggle the stud (either
double nutted, or vice gripped), until it wants to thread out.
That is the best way - The alternate is to cut it off, grind it flat, drill
the center and begin the driloing out of the center of the remaining
material. This usually done after you twist off the remaining part of the old stud!
Seth Emerson
Sethracer at aol.com
C's the day! Corvair, Camaro, Corvette
More information about the VirtualVairs
mailing list