<VV> White vacuum carb thingy

[Ron]

JB Weld has an acid etch for metal bonding and isn't made for plastics at 
all.  A craft glue would be a better choice.
RonH

----- Original Message ----- 
From: <Rt66Vairs at aol.com>
To: <larry at forman.net>; <UltraMonzaWest at aol.com>; <virtualvairs at corvair.org>
Sent: Monday, September 26, 2005 12:50 PM
Subject: Re: <VV> White vacuum carb thingy


>
> In a message dated 9/26/2005 11:01:06 AM Pacific Standard Time,
> larry at forman.net writes:
>
> The  caution I have regarding gluing it back together is that it might 
> leak
> vacuum.  I broke one and tried to snap it back together.  It held,  but 
> leaked
> vacuum and caused that carb to not work with the vacuum near zero  for 
> that
> carb.  Just plug the choke pulloff port until you are able to  get a
> replacement.  It should work OK until then or adjust the choke as  needed.
> -- Larry
>
>
>
> Larry,
>
> That's what JB Weld is for.
>
> It can be done and will probably outlive a NEW one
>
> Tim Abney
> IECC
> _______________________________________________
> This message was sent by the VirtualVairs mailing list, all copyrights are 
> the property
> of the writer, please attribute properly. For help, 
> mailto:vv-help at corvair.org
> This list sponsored by the Corvair Society of America, 
> http://www.corvair.org/
> Post messages to: VirtualVairs at corvair.org
> Change your options: 
> http://www.vv.corvair.org/mailman/options/virtualvairs
> _______________________________________________
>