<VV> starting after sitting..follow up.

[Ron]

Right, it probably has some stuck valves.  I'd pull the head and clean it up 
right.
RonH

----- Original Message ----- 
From: <TimogensTurbo at aol.com>
To: <virtualvairs at corvair.org>
Sent: Tuesday, August 01, 2006 2:06 PM
Subject: Re: <VV> starting after sitting..follow up.


> In a message dated 8/1/2006 1:44:34 PM Pacific Daylight Time,
> pbob63 at frontiernet.net writes:
>
>> My question is, can I take the bent tube and
>> rod out, and using the old rod, try to force the lifter loose by
>> hammering on it without removing anything else, then install another rod
>> and tube? I did this on one on the left side, and it is one of the ones
>> that is functioning now.
>>
> ==================================================
>
> Very doubtful it's a lifter!   The Valve Boss da Valve!   gggg
>
> The lifter has to move to bend the PR...........but the valve doesn't!
>
> Matt Nall
> stocker, mod, v8, turbo, boat, Sandcar
> ALLVAIR!
> Timogen was a softy!
> _______________________________________________
> This message was sent by the VirtualVairs mailing list, all copyrights are 
> the property
> of the writer, please attribute properly. For help, 
> mailto:vv-help at corvair.org
> This list sponsored by the Corvair Society of America, 
> http://www.corvair.org/
> Post messages to: VirtualVairs at corvair.org
> Change your options: 
> http://www.vv.corvair.org/mailman/options/virtualvairs
> _______________________________________________
>