<VV> Clark's ultimate exhausts

Louis Armer carmerjr at mindspring.com
Thu Jul 3 13:58:15 EDT 2008


>
>
>Hello All, I purchased a barely used setup from Joe White a few 
>months back. I am just getting around to fitting
>the system and I have a definite clearance problem with the chrome 
>muffler tip touching the rear valance below the
>bumper. I need some advice and possible solutions for the lack of 
>clearance. This post has already been posted to fast vairs and maybe 
>more of these systems have been installed and used by FV members 
>than VV drivers. Any suggestions and
>solutions to this obvious problem will be appreciated. I don't want 
>to melt a show car paint job or ruin the chrome plating
>on the rear bumper. Is it possible that the clearance problem is 
>caused by the thinner head packing that I used with the old
>Clark's extractors? Both Joe White and Chuck Sadek have offered some 
>advice and possible solutions but I would like to
            have more feedback from others who have purchased and 
used Clark's ultimate exhaust headers.

       Thanks,
       Chuck Armer


>
>
>
>
>
>CORSA Tri-membership Chairman
>CORSA Member
>Corvanatics Member
>Corvair Atlanta Director
>SECC Member
>1965 Corsa Coupe
>1964 Greenbrier
>1965 Corsa Autocross car 1/2 owner
>http://darthvair.com

CORSA Tri-membership Chairman
CORSA Member
Corvanatics Member
Corvair Atlanta Director
SECC Member
1965 Corsa Coupe
1964 Greenbrier
1965 Corsa Autocross car 1/2 owner
http://darthvair.com


More information about the VirtualVairs mailing list