<VV> valve adjustment
Ron
ronh at owt.com
Sun Nov 2 01:20:49 EDT 2008
Except that twisting / spinning has worked fine for the last thirty years
for me.
RonH
----- Original Message -----
From: <PatioMatt at aol.com>
To: <VirtualVairs at corvair.org>
Sent: Saturday, November 01, 2008 7:08 PM
Subject: Re: <VV> valve adjustment
>
>
>
> In a message dated 11/1/2008 6:57:32 P.M. Pacific Daylight Time,
> epssax at yahoo.com writes:
>
> Any tips? I need to adjust my valves after I removed the rocker arms. I
> will try Richard Finches method. Any tip or improvements to his method?
> He
> does 'em cold and adjusts the slack out of the push rods on the
> compression
> TDC. After the slack is out he then turns 'em all 1/4 turn. I don't
> look
> forward to crawling around and up and down while I turn the crank.
> Thanks, Ernie
> in Louisville
> ========================================
>
>
>
> Use a feeler gauge or a thick piece of paper between the rocker arm
> andValve to find 0 lash....
>
> Do not try by twisting / spinning them...
>
>
>
>
>
> Matt Nall
> Charleston, Ore.
> _http://tinyurl.com/D-MBigSingles_ (http://tinyurl.com/D-MBigSingles)
>
>
>
>
> **************Plan your next getaway with AOL Travel. Check out Today's
> Hot
> 5 Travel Deals!
> (http://pr.atwola.com/promoclk/100000075x1212416248x1200771803/aol?redir=http://travel.aol.com/discount-travel?ncid=emlcntustrav00000001)
> _______________________________________________
> This message was sent by the VirtualVairs mailing list, all copyrights are
> the property
> of the writer, please attribute properly. For help,
> mailto:vv-help at corvair.org
> This list sponsored by the Corvair Society of America,
> http://www.corvair.org/
> Post messages to: VirtualVairs at corvair.org
> Change your options:
> http://www.vv.corvair.org/mailman/options/virtualvairs
> _______________________________________________
>
More information about the VirtualVairs
mailing list