<VV> adjusting valves

[Western Canada CORSA]

Ernie,

Keep in mind that there is a difference in the proceedure depending on what
kind of lifters are in the engine as well.  The 1/4 turn is for stock
lifters, most rebuilds are going to have SBC, which I usually give a 1/2
turn to (set cold)

Regards,
Joel

-----Original Message-----
From: virtualvairs-bounces at corvair.org
[mailto:virtualvairs-bounces at corvair.org] On Behalf Of Ernie Sanders
Sent: Sunday, November 02, 2008 9:17 AM
To: VirtualVairs at corvair.org
Subject: Re: <VV> adjusting valves


Richar Finch says turn the adjustment bolt 1/4 turn after the rocker arm is
snugged up.  The factory manual says turn it one FULL turn.  Interesting!
Ernie


      
 _______________________________________________
This message was sent by the VirtualVairs mailing list, all copyrights are
the property of the writer, please attribute properly. For help,
mailto:vv-help at corvair.org This list sponsored by the Corvair Society of
America, http://www.corvair.org/ Post messages to: VirtualVairs at corvair.org
Change your options: http://www.vv.corvair.org/mailman/options/virtualvairs 
 _______________________________________________