<VV> heater troubles
N2VZD at aol.com
N2VZD at aol.com
Tue Oct 21 15:14:58 EDT 2008
still sounds like the points are not grounding...try cleaning them. next is
the condenser across them...works just like your ignition distributor.
if you are sure it is getting @3 lbs of pressure at the inlet , be careful
the first time it does get spark. i am assuming a lot here , such as spark
gap tested , little tiny screen is clean under the fuel inlet fitting (a bugger
to get back in place) spark tested at the plug lead with a test plug , etc.
it is well covered in the service manual. i did find that nos repair kits do
not make it. get a fresh one from clarks so the small rubber seal is
pliable , not hard as a rock from age. my gas heater fun began after getting a load
of bad gas while on a trip...THEN i discovered the tiny filter screen.
this is kinda how you learn?
regards, tim colson
**************New MapQuest Local shows what's happening at your destination.
Dining, Movies, Events, News & more. Try it out
(http://local.mapquest.com/?ncid=emlcntnew00000002)
More information about the VirtualVairs
mailing list