<VV> Early rear wheel cyl removal

[Bryan Blackwell]

Ah, the fog slowly lifts!  Thanks Frank and everyone else.  I will  
see about greasing the bearing as well.

--Bryan

On Feb 3, 2009, at 11:36 AM, corvairduval at cox.net wrote:

> The rears are held by two 1/4-20 very short bolts from the back  
> side of the
> backing plate.  You must be looking at the front replacement cylinder.
>
> And they are 3/8 head bolts if factory. 7/16 head is the  
> replacement bolt.
> Soak with penetrant of your choice and use a six point socket, as  
> these are
> usually very rusty here in the east.
>
> The axle does not need to be removed from the car, just slid as far  
> as the
> u-joint will allow. Then the backing plate can be slid off the studs.
>
> Frank DuVal