<VV> Rear motor mount
J R Read_HML
hmlinc at sbcglobal.net
Tue May 5 01:49:48 EDT 2009
I'll just say... that is not what I do. Somewhere in the archives (probably
5ish years ago), you will find it.
Later, JR
----- Original Message -----
From: <airvair at earthlink.net>
To: "J R Read_HML" <hmlinc at sbcglobal.net>; "Stephen Upham"
<contactsmu at sbcglobal.net>; "Virtual Vairs" <virtualvairs at corvair.org>
Sent: Tuesday, May 05, 2009 12:13 AM
Subject: Re: <VV> Rear motor mount
> Jack on the place where the three body seams come together. That way, if
> you're careful in where you place the floor jack, you can still set the
> jackstand directly in the middle of the triangle. It will also allow both
> front and rear wheel to come off the ground, and you can put two
> jackstands
> under that side. Handy if you only need one side raised, though not
> recommended if you are also going to raise the other side. In that case,
> put only the rear jackstand under the car. Then raise the other side the
> same way. After that, raise the front with the floor jack lifting the
> center of the crossmember. Then insert the two front jackstands behind the
> front wheels and under the front frame struts.
>
> -Mark
>
>
More information about the VirtualVairs
mailing list