<VV> Dual master cylinder question

[shortle]

Hi Jim, I picked up 2 hydraulic brake lines from a wrecking yard (about 8 inches long) and have bent them to exit into the MC reservoir BELOW the fluid level. I then mount the MC in a bench vise and just push on the push rod/primary piston all the way in a # of times. Guaranteed bench bleeding. I hope this is helpful to you.
Timothy Shortle in Durango Colorado 

-----Original Message-----
>From: Jim Houston <jhouston001 at cfl.rr.com>
>Sent: Nov 15, 2009 12:01 PM
>To: Virtual Vairs <virtualvairs at corvair.org>
>Subject: <VV> Dual master cylinder question
>
>I bought a dual master cylinder to install on my Corsa.  It did not come 
>with the fittings to bench bleed the MC.  The FLAPS where I bought it 
>checked other boxes and none of them have the fittings.  They also don't 
>have any "kits" available.  Anybody got a suggestion for obtaining the 
>necessary fittings for doing a bench bleed???
>
>Thanks in advance,
>
>Jim Houston
>'65 Corsa coupe
> _______________________________________________
>This message was sent by the VirtualVairs mailing list, all copyrights are the property
>of the writer, please attribute properly. For help, mailto:vv-help at corvair.org
>This list sponsored by the Corvair Society of America, http://www.corvair.org/
>Post messages to: VirtualVairs at corvair.org
>Change your options: http://www.vv.corvair.org/mailman/options/virtualvairs 
> _______________________________________________