<VV> nut size

shortle shortle556 at earthlink.net
Sat Jan 30 11:53:48 EST 2010


It's the same size that holds the carburetors on, so long it is a naturally aspirated engine.
Timothy Shortle in Durango Colorado.


-----Original Message-----
>From: Ron <ronh at owt.com>
>Sent: Jan 30, 2010 9:34 AM
>To: John Kepler <jekepler at amplex.net>, N2VZD at aol.com, virtualvairs at corvair.org
>Subject: Re: <VV> nut size
>
>I'm glad somebody speaks sense!
>RonH
>
>----- Original Message ----- 
>From: "John Kepler" <jekepler at amplex.net>
>To: <N2VZD at aol.com>; <virtualvairs at corvair.org>
>Sent: Saturday, January 30, 2010 4:57 AM
>Subject: Re: <VV> nut size
>
>
>>
>>
>> it is fine thread 5/16.  do not over tighten!!
>> regards, tim colson
>>
>>
>> For those more of an engineering persuasion....that's a 5/16x24!
>>
>>
>>
>>
>> _______________________________________________
>> This message was sent by the VirtualVairs mailing list, all copyrights are 
>> the property
>> of the writer, please attribute properly. For help, 
>> mailto:vv-help at corvair.org
>> This list sponsored by the Corvair Society of America, 
>> http://www.corvair.org/
>> Post messages to: VirtualVairs at corvair.org
>> Change your options: 
>> http://www.vv.corvair.org/mailman/options/virtualvairs
>> _______________________________________________ 
>
> _______________________________________________
>This message was sent by the VirtualVairs mailing list, all copyrights are the property
>of the writer, please attribute properly. For help, mailto:vv-help at corvair.org
>This list sponsored by the Corvair Society of America, http://www.corvair.org/
>Post messages to: VirtualVairs at corvair.org
>Change your options: http://www.vv.corvair.org/mailman/options/virtualvairs 
> _______________________________________________



More information about the VirtualVairs mailing list