<VV> electronic ignition help!!

[shortle]

Very good system. The RED wire goes to the positive side of the coil. There it is joined by the 12 volt wire from the ignition system switch. The black wire will be the only wire on the negative side of the coil (unless you have a tachometer).
Timothy Shortle in (hot) Durango Colorado


-----Original Message-----
>From: akacube at aol.com
>Sent: Jun 6, 2010 4:02 PM
>To: VirtualVairs at corvair.org
>Subject: <VV> electronic ignition help!!
>
>
>
>Thanks to all that have replied and I apologize for not providing the brand of ignition it is a Petronix Flame Thrower coil and the module, p/n 02AE-V5, has a red and black wire. It seems that the black wire is the negative that goes on the coil and the red is the positive but does it go to the positive coil terminal or to a 12V wire from the ignition? Also, some of you had mentioned somthing about a gap between the rotor and the electronic module. This module came with a spacer that I believe goes on after the ignition plate is mounted and the rotor then sits on top of this spacer which then places the rotor above the module. The module looks to be completely sealed. Again thanks for all of your help.
>Abe
> _______________________________________________
>This message was sent by the VirtualVairs mailing list, all copyrights are the property
>of the writer, please attribute properly. For help, mailto:vv-help at corvair.org
>This list sponsored by the Corvair Society of America, http://www.corvair.org/
>Post messages to: VirtualVairs at corvair.org
>Change your options: http://www.vv.corvair.org/mailman/options/virtualvairs 
> _______________________________________________