<VV> 65-66 turn signal switch

[Ray R. (aka Grymm)]

I also have a troublesome repro turn signal switch (65-66) purchased in the 
last year.  I was told that the repro's sometimes need some tinkering to 
work right...  I still haven't taken it back apart to fiddle with it... left 
works fine, right activates only the rear light and not the indicator or 
front light unless I hold it up with a finger....  it also doesn't cancel 
properly from a right turn but that may be due to my wheel still being off 
center.. another little thing I need to fine tune.

Ray R.


----- Original Message ----- 
From: "Gary Swiatowy" <gswiatowy at rochester.rr.com>
To: <virtualvairs at corvair.org>
Sent: Saturday, June 26, 2010 6:43 PM
Subject: <VV> 65-66 turn signal switch


>
>
> Last year I purchased a new turn signal switch for my 66 Monza.
> A year later, almost, I have problems with the left brake light staying 
> on.
> Pulled the steering wheel, and noticed some of the brass springs had come
> out of place.
> Pushed them back into place, and it worked fine.
> Used the signals on and off about 10 times and found the same problem.
> Including erratic functioning of the signals.
> Is this just an isolated incident?
> Or are the repro's not up to par?
>
> Gary Swiatowy
>
> _______________________________________________
> This message was sent by the VirtualVairs mailing list, all copyrights are 
> the property
> of the writer, please attribute properly. For help, 
> mailto:vv-help at corvair.org
> This list sponsored by the Corvair Society of America, 
> http://www.corvair.org/
> Post messages to: VirtualVairs at corvair.org
> Change your options: 
> http://www.vv.corvair.org/mailman/options/virtualvairs
> _______________________________________________