<VV> Fw The magic 9/16

[kenpepke at juno.com]

Smitty, youse is absolutly right!  And it is the first time I have heard channel locks described as a 'stretchy 9/16'  Good description :-))
Ken P


*********************
"Smitty" <vairologist at cox.net>
To: <virtualvairs at corvair.org>
Subject: <VV> The magic 9/16
Date: Sun, 7 Nov 2010 16:51:55 -0500

> You certainly need a stamped 1 inch wrench to tighten a carburetor inlet 
> nut
> when it comes loose and starts leaking.
> RonH
=============================
Smitty Says;  Not Ken.  He has one of those stretchy 9/16 that will fit any 
bolt on the car.  (Smile).  As a matter of fact I have heard that he takes 
off alternator pulley nuts with the same wrench.  He uses it on ball joint 
nuts and tie rod end nuts and to tighten the nuts on the ignition coil 
wires.too.

 

____________________________________________________________
D&O Insurance
Indemnity from the Top Down - By Elizabeth Wasserman
http://thirdpartyoffers.juno.com/TGL3141/4cd7fd92a169d102adcst05duc