<VV> Grease Rear Wheel Bearings

[Ken Clark]

Jerry- I have put grease fittings in all my late model rear bearing hubs with success,(if they are still good and not grinding) and that is done by drilling into the hub and using a tap the size of the fitting.  Need to know where to drill and not let metal shavings go into the hub.  I have it on all mine and have had for years with no problem.  Just pump the grease in and not over grease it.  You will probably have a lot of negative remarks on this one, but it does work.   Ken Clark
 

> To: virtualvairs at corvair.org
> From: jww1945 at aol.com
> Date: Sun, 27 Nov 2011 11:10:12 -0500
> Subject: <VV> Grease Rear Wheel Bearings
> 
> 
> I would like to do a PM of the rear wheel bearings on my '65 Corsa. Car has 77,000 miles and I am sure the bearings have not been touched since 1965.
> 
> The little I know suggests it is not an easy project.
> 
> Can someone tell me where I can find a step by step approach to this project?
> 
> Thanks,
> Jerry Wells
> _______________________________________________
> This message was sent by the VirtualVairs mailing list, all copyrights are the property
> of the writer, please attribute properly. For help, mailto:vv-help at corvair.org
> This list sponsored by the Corvair Society of America, http://www.corvair.org/
> Post messages to: VirtualVairs at corvair.org
> Change your options: http://www.vv.corvair.org/mailman/options/virtualvairs 
> _______________________________________________