<VV> Need help putting 110 PG Bellhousing onto 140 hp ENGINE

[Matt Nall]

I bought a 140 block (reported to run) at GWFBT and I was going to convert
to a Saginaw 4-speed (also bought there) but want to get it running to make
sure the engine is good enough to go the Saginaw 4-speed route first.

Charlie


======================================================================


1  Yep  just a bolt on!  Remove pilot bushing in 140 engine....remove oil pan, then bellhousing..swap parts and use new seals and gaskets and you are ready to go!


2  To test run an engine  on the floor  is a simple and standard practice!    New or used engines!


see  http://youtu.be/oJ0WT_dwmEA



Matt Nall
Charleston, Oregon
http://tinyurl.com/The-Corvair-Patio

http://tinyurl.com/Matts-Tech-Pages