<VV> Need help putting 140 block into PG-same flexplate as 140?

[Sethracer at aol.com]

flexplates are interchangeable, but remember, with a PG, the torque  
converter must be installed to start the engine. even on the ground.  It  has the 
ring gear on it, like the clutch cover with a manual trans. - Seth
 
 
In a message dated 4/21/2014 6:13:54 P.M. Pacific Daylight Time,  
chaz at properproper.com writes:

Thanks  !



Is the PG flexplate the same for the 110 & 140 ? (i.e.  can I just move it
over to the  140?)



Charlie



From: CORSABILL at aol.com  [mailto:CORSABILL at aol.com] 
Sent: Monday, April 21, 2014 11:00 AM
To:  chaz at properproper.com
Subject: Re: <VV> Need help putting 140 block  into PG





Charlie:

Oil pans are the same.   Pilot bushing OUT, not change.



Need mufflers as the noise will  be so great you cannot tell how it is
running.



If the 140  has a flywheel, it comes off and flex plate goes in place.   PG
flexplate

needed regardless.



Hope this  helps.



Bill Loftin  

_______________________________________________
This message was  sent by the VirtualVairs mailing list, all copyrights are 
the property
of  the writer, please attribute properly. For help,  
mailto:vv-help at corvair.org
This list sponsored by the Corvair Society of  America, 
http://www.corvair.org/
Post messages to:  VirtualVairs at corvair.org
Change your options:  
http://www.vv.corvair.org/mailman/options/virtualvairs  
_______________________________________________