<VV> Driveline swap

[J. R. Read]

Yes, that is correct - bell housing has to go onto the 140 engine.  If he 
gets lucky he MIGHT get away with using the existing pan gasket.

Later, JR

----- Original Message ----- 
From: "BBRT" <chsadek at comcast.net>
To: "J. R. Read" <hmlinc at sbcglobal.net>; "Smitty" <vairologist at cox.net>; 
<virtualvairs at corvair.org>
Sent: Wednesday, May 28, 2014 6:24 PM
Subject: Re: <VV> Driveline swap


> That's how I see it but he has to transfer bellhousing, flexplate to 140.. 
> etc.
> ----- Original Message ----- 
> From: "J. R. Read via VirtualVairs" <virtualvairs at corvair.org>
> To: "Smitty" <vairologist at cox.net>; <virtualvairs at corvair.org>
> Sent: Wednesday, May 28, 2014 7:19 PM
> Subject: Re: <VV> Driveline swap
>
>
>> Ahhh - He's got everybody confused.  The way I understand it is a 110 is 
>> going out and a 140 is going in.  The PG tranny is not going anywhere. 
>> So, neither is the bell housing.
>>
>> Do I have it wrong?
>>
>> Later, JR
>>
>> ----- Original Message ----- 
>> From: "Smitty via VirtualVairs" <virtualvairs at corvair.org>
>> To: <virtualvairs at corvair.org>
>> Sent: Wednesday, May 28, 2014 5:50 PM
>> Subject: <VV> Driveline swap
>>
>>
>>> Smitty Says;  Guys I know I am old and slow and maybe a little stupid 
>>> about what is going on.  Aren't you over simplifing this.  Don't you 
>>> have to change the bell housing too to accomplish a PG to stick 
>>> driveline swap and visa versa.  I read back a ways in the thread and 
>>> found no mention of this.


---
This email is free from viruses and malware because avast! Antivirus protection is active.
http://www.avast.com