<VV> engine break in advice

[MarK Durham]

Most of the break-in has already taken place. Go drive the car making
smooth accelerations as you pull from stops. I am assuming cast iron rings?
When you get close to the 100 miles do a few high power accelerations to
finish it off then go change the oil and filter and drive normally.

Mark Durham
Hauser Idaho
62 Coupe
On Apr 8, 2015 9:17 AM, "Michael Kovacs via VirtualVairs" <
virtualvairs at corvair.org> wrote:

>  Block not opened. New pistons, rings, con rod bearings, valves, lifters
> etc. Pistons and con rods balanced. iron rings +60.
>  It has run at 1500 for about 15 min and sounds OK, 35 lbs oil pressure. I
> want more advice for the 100 mile break in run. Oil and filter changed
> after that.
>  _______________________________________________
> This message was sent by the VirtualVairs mailing list, all copyrights are
> the property
> of the writer, please attribute properly. For help, mailto:
> vv-help at corvair.org
> This list sponsored by the Corvair Society of America,
> http://www.corvair.org/
> Post messages to: VirtualVairs at corvair.org
> Change your options:
> http://www.vv.corvair.org/mailman/options/virtualvairs
>  _______________________________________________